EVS XT2+ Manual do Utilizador descarregar pdf (Página 15)

When Starting the EVS Server After Initial Configuration

After the initial configuration, you will select a configuration line and press ENTER to run

the server in this configuration. See section "Launching a Configuration" on page 12. As

soon as the EVS server is launched in a configuration, it starts the loop recording process.

1.4. Accessing the Web-Based Interface

Prerequisite

When the EVS server is started, you can access the web-based interface of the Multicam

Setup application for that EVS server from any machine (PC or server) that is on the same

network range as the EVS server. You can use any browser to open the web-based

interface.

Procedure

To be able to open the web-based interface in a browser, you need to know the IP address

of the PC LAN of the EVS server. See section "Setting the Server LAN PC Address" on

page 25 for more information.

In your browser, enter the following URL: http://xxx.xxx.xxx.xxx/cfgweb/ where the

crosses correspond to the PC LAN IP address of the EVS server you want to access.

XT2+ Server- Version 11.01- Configuration Manual

1. Introduction 5

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 233 234

Sem comentários

EVS XT2+ Manual do Utilizador Página 15