EVS XT2+ Manual do Utilizador descarregar pdf (Página 39)

XT2+ Series DISK RECORDER - Version 10.05 - Hardware Technical Reference Manual

Issue

10.05.A

EVS Broadcast Equipment SA – July 2011

• Typical switching point @ 1.4 mA, for secure operation:

o i=0 to 0.5 mA -> opto OFF

o i=2.5 to 30 mA -> opto ON

o imax= 30 mA

• Direct connection to a TTL/CMOS signal possible (Pin opto - to GND and pin

opto + to the TTL/CMOS signal.

Typical switching point @ 1.6 Volts, for secure operation:

o Vin< 0.8 Volts -> opto OFF

o Vin> 2.2 Volts @ 2 mA -> opto ON

o Vin max (without external resistor) = 15 Volts

4 X CMOS input/output:

•

each pin can be individually configured as an output or an input

• internal 4K7 pull up to +5V

• low level Vi<1.5 Volt (U12=74HC245)

• high level Vi>3.5 Volt (U12=74HC245)

• optional TTL compatible level (U12=74HCT245)

2.5 RS422 CONNECTOR

The RS 422 cable must be wired PIN TO PIN following the above diagram. Use

shielded cable to avoid electromagnetic interference on long distances.

Important

The Reset command from the Remote is sent through the Pin n°5 of

RS422 connector. This function should be disabled when the controller

on RS422 #1 is not an EVS controller

(refer to the section ‘MTPC Board’

on page 74 of this manual).

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 86 87

Sem comentários

EVS XT2+ Manual do Utilizador Página 39